Suggest an editImprove this articleRefine the answer for “What is the main function of the OSI physical layer?”. Your changes go to moderation before they’re published.Approval requiredContentWhat you’re changing🇺🇸EN🇺🇦UAPreviewTitle (EN)Short answer (EN)**The physical layer (Physical Layer, layer 1)** is responsible for *the physical transmission of bits over a communication medium*. The main function of the physical layer is converting digital data into electrical, optical, or radio signals and transmitting them over the physical medium (cable, fiber, radio). **Key point:** the physical layer does not know what IP, MAC, frames, packets, or ports are - it only transmits a stream of bits.Shown above the full answer for quick recall.Answer (EN)Image**The physical layer (Physical Layer, layer 1)** is responsible for *the physical transmission of bits over a communication medium*. Short formulation for an interview: > **The main function of the physical layer is converting digital data into electrical, optical, or radio signals and transmitting them over the physical medium (cable, fiber, radio).** This is the lowest layer of the OSI model. --- ## In detail: what the physical layer does The physical layer **does not know** what IP, MAC, frames, packets, or ports are - it only transmits a **stream of bits**: #### Transmits 0s and 1s as signals: - electrical (copper / twisted pair) - optical (fiber optics) - radio waves (Wi-Fi, Bluetooth) #### Defines the parameters of the medium: - cable type (UTP, STP, coaxial, fiber) - cable length - connectors (RJ-45, LC, SC) - frequency range (radio) #### Defines physical characteristics: - voltage levels - transmission frequency and speed (bitrate) - modulation type - signal synchronization (clock frequencies) #### Provides the physical connection: - connecting devices - activating/deactivating lines - carrier detection --- ## A simple analogy The physical layer is the **wires and signals** that "carry" the bits. Just as a phone wire carries sound, the physical layer carries zeros and ones. --- ## What the physical layer does NOT do To avoid confusion, it's important to know that the physical layer is **not** responsible for: - MAC addresses - frames - routing - data-link-level errors - the logical structure of the network That is the job of the upper layers (L2 and above).For the reviewerNote to the moderator (optional)Visible only to the moderator. Helps review go faster.